Readying Slave Drive For WIN XP
F2 to enter Setup Utility."Can anyone tell me what I'm doing wrong? If you are confident in yourself and would like to save the money a computer guy would charge to do it, go ahead and do it yourself. See more Second Hard Drive not recognized Internal hard disk usb device not reconized Maxtor internal hard drive not recognized Second hard drive not recognized Internal second hard drive not recognized? The laptop has only 2 GB of RAM and a single Core CPU and would run XP much better than it does Windows 7. check over here
next I rebooted my computer... The primary drive on a channel is called the Master, and the secondary one is called the Slave. Do not apply pressure or attach labels to the circuit board or the top cover of the drive. If you can remove the hard drive, you can get a USB enclosure and slave the drive that way.
What Is A Slave Hard Drive
Reply greg on April 27, 2009 at 9:12 pm I would first try cable select though I cannot verify the results. Keep up the good work Reply Richard on August 10, 2007 at 9:10 am My 2nd EIDE (XP) drive installed with surprising ease -- no BIOS or jumper changes (cable select). DTI Data Recovery August 24, 2008 2:32 pm Reply # Sheba - I have sent this to Jacqui, our tech support guru. is there a way to slave it to a laptop that runs win xp pro?
If they aren't then you've got some troubleshooting to do. If not, then it is safe to re-format it. The Master drive goes on the black connector at the end of the cable, the slave drive connects to the gray connector in the middle and the host adapter connects to How To Slave A Hard Drive To Recover Data Each channel can have 2 devices on it.
You constantly get a message that space on drive c is dangerously low, which it is. How To Slave A Hard Drive Windows 7 Try another setting on the Primary Slave. Thanks! All rights reserved.
Then I checked BIOS, and after that, I let it boot. Slave Hard Drive Definition if I get another, I'll just cycle the old one out. Register now Not a member yet? Your thoughts?
How To Slave A Hard Drive Windows 7
Pye May 23, 2007 7:18 pm Reply # Ok-I am not a tech, but do both the slave and master drive have to have the same operating system? Does it need to be the same operating system. What Is A Slave Hard Drive share|improve this answer answered Dec 8 '11 at 17:56 Amit Ranjan 14529 add a comment| up vote 0 down vote Man I am not saying this is not "possible"... How To Slave A Sata Hard Drive If I put the old drive in an external drive case, can I clone from this location versus the internal cable?Thanks.
what action should i do? check my blog I tried what u said to do to change it to auto and everything was already set to auto. To answer the best I can. There are several different forms of data storage available. How To Slave A Laptop Hard Drive
On a SATA hard drive, position of the drives on the cable does not matter at all because a SATA cable only accomodates one drive.Plug the system in and turn it The hard drive doesn't even power up: Check to make sure the IDE cable is connected correctly. floppy. this content One is used by my system hard drive (the drive that came with my computer), and the other is used by my SATA CD/DVD drive.
You are right, it isn't. Install Old Hard Drive In New Computer Will any of these work? Is there a way to do it without paying for converts?
When you first start your machine enter into the BIOS and make sure the drive was identified properly.
It's just sorting them out. To others out there who are stumped by techy terminology, I suggest browsing a little bit more sites & things will fall into place. You should be able to read what it can & can not do. Slave Hdd Or, is there a special cord that will connect to both drives?
This was a really helpful tutorial…BUT I need to know how to slave a SATA to a IDE. Thanks for your time Reply Mitch on August 17, 2007 at 3:58 am Thanks alot, THE BEST step by step tutorial that I have found. Will the presence of a corrupt ME on the slave disk cause a problem, before I can pull off the datafiles? have a peek at these guys We have software that can recover your data.
Most of my family's computers now have two hard drives and two CD/DVD/players/burners for a lot of flexibility. Reply Norm on September 23, 2009 at 12:21 am Having the same problem. Passing along to the co-workers. Follow this Windows 10 Redstone 2 14894 … How to Update Windows 10 to Threshold 2 with Backups?. 2015-12-01 14:57:14 Tracy King - Here in this passage you’ll find detail steps
Once this is done buy the wire thing that connects my old one to the new one. What they need is to study "Computers for Dummies" first -then- read this article. I need to know what operating system you are using on your computer that you hook the external hard drive up to. unfortunately it has two drives so I'm starting with #2 thinking that is probably the "D" drive that I use for files, music and pics as opposed to the OS (hoping
Here is a link superuser.com/questions/42263/… –OG Chuck Low Dec 10 '11 at 18:43 add a comment| up vote 0 down vote I would install the slave HD into another computer, and It could just be a corrupt file the local fix-it shop says.So when I use the usb thing with my laptop harddrive inside it, to hook to my desktop or another